Adapters/Mounting - Devices Mini Series
TG Series - - Single Side Band Back Stay Antenna


191 VARNEY STREET, MANCHESTER, NH 03102 Phone 603 627-1010 Fax 622-4738 info@gamelectronicsinc.com

				Adapters and Mounting Devices



	FOR MINI SERIES
	1.	SS-B	Right angle mounting bracket
	2.	ADAP-I	Durable plastic adapter for standard marine lay down mount Prewired socket accepts an MINI antenna and is supplied with 20' RG-58 coaxial cable.
	3.	ADAP-II	Same as ADAP-I except is fed out of bottom for extensions.
	4.	"Motorola" Adapter	Attaches to any "Motorola" type chassis mount and provides a socket to receive any MINI antenna.
	5.	Magnetic Mount	Pre-wired 5/8-24 socket on a 3¼ chrome coated magnet base Rated pull is 90-100 pounds. 20' RG-58 cable.
	6.	P-M-A Pipe Mount	For use on standard 1¼" pipe Top is threaded to 5.8-24 to accept MINI antenna.


	FOR TG SERIES
	7	M-M-A Marine Mount	Adapts TG-Series antennas to standard marine lay down mount.

	LORAN/DGPS
			52" tapered stainless steel whip with a 3/8-24 termination to fit standard coupler

191 VARNEY STREET, MANCHESTER, NH 03102 603 627-1010 Fax 622-4738
info@gamelectronicsinc.com

MINI – SERIES

GENERAL

Every loading coil is hand wound, factory turned and tested to insure peak performance at specified frequency
VSWR is 1.5:1 or less
Gain is 6 db over coaxial antenna
Power rated at 150 watts
Coil housing is stainless steel, sealed to prevent moisture damage
No ground plane required

STANDARD MODELS

VHF antenna for 144-174
MHz marine antennas tuned to 156.8MHz
Whip length is 30"-40"; 35" for marine

USS-2

UHF antenna for 430-470 MHz
Whip length is 11" - 15"

88 - 108 MHz for FM
Whip length is 54"

Weather Fax

Specifically tuned to maximize signal strength for improved fax reception
Whip length is 54"

Cellular

Broad banded to insure maximum signal strength over 800-900MHz
Whip length is approximately 5.6"

SS-27	"Citizen's Band" antenna Whip length is approximately 54" but will vary with specific installation Note: "CB" antenna does require a ground reference
SS-220	VHF antenna for 220 MHz. Whip length is 25"
SS-138	VHF antenna for 138 - 140MHz. Whip length is 40"

All whips over 25" are tapered to minimize wind resistence.

Special frequencies are quoted on request.

191 VARNEY STREET, MANCHESTER, NH 03102 603 627-1010 Fax 622-4738
info@gamelectronicsinc.com

T G - SERIES

GENERAL

Every loading coil is hand wound, factory turned and tested to insure peak performance
VSWR is 1.5:1 or less
Power rating is up to500 watts
Coil housing is 606-T6 aluminum and is designed to mount on standard 1¼" pipe
Mast sections are either 6061-T6 aluminum or stainless steel

STANDARD MODELS

TG-3

VHF antenna for 144-174
Gain is 6 db over coaxial atenna
Rated wind load with ½" of ice is 100 MPH
Assembled length is approximately 42"

TG-3-(SH)

VHF antenna for Base Station or Marine
TG-3 is for 144-160 MHz
TG-3-SH is for 156-174 MHz
Gain is 9 db over coaxial antennas
Mast consists of two radiating elements interconnected by a ½" wave phasing section
Rated wind load with ½" of ice is 100 MPH
Weight is 2 pounds, 13 ounces
Assembled length is 96"
Knocked down length is 57"*

TG-5-S(SH)

VHF antenna for Base Station or Marine
TG-5-S is for 144-160 MHz
TG-5-SH is for 156-174 MHz
Gain is 10.5 db over coaxial antennas
Mast consists of three radiating elements interconnected two ½" wave phasing sections
Rated wind load with ½" of ice is 75 MPH
Weight is 3 pounds, 8 ounces
Assembled length is 154"
Knocked down length is 57"*

Each of these antennas is available for aircraft band (118-136 MHz) and 220 MHz.

*Knocked down length allows UPS shipment as a standard package.

191 VARNEY STREET, MANCHESTER, NH 03102 603 627-1010 Fax 622-4738
info@gamelectronicsinc.com

Gam / McKim
Split Lead Antenna

Patent Pending

GENERAL

The Gam / McKim Split Lead Single Side Band Antenna eliminates the need for backstay insulators forever. No longer must the integrity of backstays be compromised by cutting and installation of costly insulators. The Split Lead antenna simply press fits onto your existing backstay wire...no special tools required...and is secured at both ends by a simple plastic clamp.

Consider the following:

Safety: The split lead antenna installation requires no alteration of the backstay thus preserving full mechanical integrity of the backstay wire.

All RF elements of the antenna are fully insulated eliminating the possibility of the shock hazard posed by the bare wire connection in conventional backstay antennas.

Ease of Installation: No cutting, no swaging, no measuring, no special tools, no special skills required...simply press fit over the existing backstay wire and clamp at top and bottom

Performance: Active elements are designed for RF...more conductive than the stainless steel backstay wire.

Lead wire connections are waterproof and electrically sound...no more corrosion where the bare copper wire is wrapped around the stainless steel backstay.

The antenna's insulated housing reduces "Precipitation Static" often associated with heavy squalls and thunderstorms.

Stowage and Portability: The Split Lead antenna can be coiled up to a diameter of approximately 26" for ease of storage

It can be easily removed when the mast or backstay require work and can readily be transferred from one vessel to another.

Durability: The outer housing is very durable, resistant to weathering and, since it under no mechanical stress, should last for may years in the marine environment.

Cost: The GAM / McKim Split Lead Antenna is priced to compete with conventional backstay insulators (including swaging costs) and less expensive than many insulators utilizing reusable terminals.

With Gam Electronics antennas you will always get the best quality products without compromise and at a fair price.

191 VARNEY STREET, MANCHESTER, NH 03102 603 627-1010 Fax 622-4738
info@gamelectronicsinc.com

Direct Sale Price List
01-01-11

MODEL	SUGGESTED LIST

SS-2, VHF(144-174MHz)	$70.00
USS-2, UHF(420-470MHz)	$70.00
138-140MHz	$70.00
220MHz	$70.00
800MHz	$70.00
FM	$70.00
Cellular, analog only	$70.00
SS-27(CB)	$70.00
SS-B, right angle mounting bracket	$5.35
Magnetic Mount	$42.80
NMO type adapter	$18.45
ADAP-I or II	$21.50
TG-3 VHF Base Station	$130.00
TG-3-S(SH) Base Station	$215.00
TG-5-S(SH) Base Station	$370.00
MMA adapter	$43.50
GAM/McKim Split Lead Single Side Band	$465.00

Prices are FOB factory

* Prices are subject to change without notice.

191 VARNEY STREET, MANCHESTER, NH 03102 603 627-1010 Fax 622-4738
info@gamelectronicsinc.com

MODEL

SUGGESTED LIST